DO NOT LIFT THE CABINET HIGHER THAN NECESSARY TO CLEAR THE FLOOR WHEN MOVING NOTE: FROM FLOOR TO CABINET LIFTING POINT IS 3. USE A FORKLIFT OR SIMILAR DEVICE WITH APPROPRIATE. Lock...
HOME / Can the UPS battery cabinet be moved as a whole - LUP MICROGRID
Can the UPS battery cabinet be moved as a whole - LUP MICROGRID [PDF]
This manual contains important instructions that should be followed during installation of your Liebert® EXM Battery Cabinet and accessories. Read this manual thoroughly, paying special attention to the
If not already accomplished, use a forklift or pallet jack to move the battery cabinet to the installation area, or as close as possible, before unloading from the pallet.
REMOTE BATTERY CABINET SYSTEM: ALL CABLE HARNESSES FROM BATTERY CABINET TO BATTERY CABINET AND BATTERY CABINET TO UPS WILL BE PROVIDED BY THE
Move at a slow pace and pay close attention on the floor conditions and the balance of the cabinet. Failure to follow these instructions can result in death, serious injury, or equipment damage.
Once the battery cabinet is configured with UVR access, wait until the UPS outputs its rated UVR voltage, prior to turning on the circuit breaker. • UVR/Shunt Pin 1 = POSITIVE (+) Polarity
Over the life of your UPS, it may become necessary to retrofit or upgrade your existing battery system, including your battery cabinet or rack, to maintain
Route cables before moving cabinets into final position for bolting together. No top or bottom entry cables are required, except for remotely located cabinets which require conduits.
Is there anyway you guys know of that this could be moved into elevator and into place without removing batteries? It will fit in elevator and the weight capacity is okay.
Two chunks of rigid pipe for rollers will move anything, anywhere. Just be careful where you place the pipes so that you always have one of them
It may be to make physically moving in the cabinet easier to roll, or it might be in order to get below a weight limitation for an elevator. To answer the